Movincool Office Pro 12 / Office Pro 18 / Office Pro 24 Service Manual download pdf (Page 11)

Operation Section

3.5 Air Flow

• Air drawn from the right side face passes through the condenser which extracts the heat. This

hot air is blown out through the upper exhaust air duct. Air taken in from the front face is cooled

by the evaporator and then blown through the cool air vent. All the air inlets are equipped with

filters, and the exhaust air duct is protected by metal grill.

3.6 Compressor and Fans

• The compressor is hermetically sealed. Two sets of a two-speed fan motor with a centrifugal fan

are used to draw air across the evaporator and condenser.

3.7 Condensate Pump

• The condensate pump and a 20 ft (6 m) drain hose are included with the Office Pro 60 to provide

continuous operation without the need of the drain tanks. The condensate pump has a maximum

head lift of 17 ft (5.2 m) at 230 VAC or 13 ft (4.0 m) at 208 VAC.

3.8 Drain Tanks (optional)

• A set of two 5.0 gal (19 L) drain tanks are supplied as optional accessory for Office Pro 60. When

drain tanks are used instead of condensate pump, the condensate (water) is collected into both

tanks. The drain switch activates and stops the operation when tanks reach the level of

approximately 8.0 gal (30 L).

I001909

Condenser Air In

Evaporator Air In

Exhaust Air Out

Cool Air Out

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 68 69

No comments

Movincool Office Pro 12 / Office Pro 18 / Office Pro 24 Service Manual Page 11