Movincool OFFICE PRO 12 Specifications

OPERATION MANUALOFFICE PRO 12 / OFFICE PRO 18 / OFFICE PRO 24Unit Serial Number Range: 0711XXXX### to Present(From July 2011 to Present)READ THIS MANU

10INSTALLATION (cont.)Plugging in the Unit1. Check the prongs and surface of the power cord plug for dust/dirt. If dust and/or dirt are present, wipe

11INSTALLATION (cont.)Plugging in the Unit (cont.)CAUTION: The power source should be a dedicated single outlet circuit with UL recognized short-circu

12INSTALLATION (cont.)Warning Signal Connection (Output Signal Terminal L+ and L-)The controller is equipped with a warning signal output relay type (

13INSTALLATION (cont.)Fire Alarm Control Panel Connection (Input Signal Terminal E+ and E-)The controller is equipped with a normal open input signal

14INSTALLATION (cont.)LCDI Power Cord InstructionWARNINGCAUTIONProcedure<FRONT VIEW>The LCDI device is a non-serviceable device.Attempting to op

15FEATURESFor all models:1. A digital electronic control panel, which allows the user to easily control the unit’s operation.2. Dual fan speeds (eithe

16OPERATIONControl PanelBefore operating the unit, it is important to familiarize yourself with the basic controls located on the control panel.1. COO

17OPERATION (cont.)Control Panel (cont.)LCD IndicatorsNote: ROOM TEMP display range is from 16 °F to 109 °F (-9 °C to 42 °C). When the display value i

18OPERATION (cont.)Operating ModesThe Office Pro 12, Office Pro 18, and Office Pro 24 can be operated in two modes, FAN ONLY and COOL. When in FAN ONL

19OPERATION (cont.)Set ClockPrior to operating the Office Pro 12, Office Pro 18, or Office Pro 24 users should set the clock of the controller to the

SERIAL NUMBER LOCATION AND IDENTIFICATIONNameplate Label PositionNameplate LabelCOOLING AMPS. WITH PUMPCOMPR. OUTPUTREFRIGERANT/TOTAL CHARGEDESIGN PRE

20OPERATION (cont.)Operating in FAN ONLY Mode1. The unit can also be operated in FAN ONLY mode by pressing FAN HI/LO button (LCD indicates “FAN HI/LO”

21OPERATION (cont.)How to Set a ProgramSET START TIME1. Press and hold the SET PROG button for 3 seconds or until beep.2. Press SET TEMP buttons to sc

22OPERATION (cont.)How to View and Delete Program1. Press and hold the SET PROG button for 3 seconds or until beep.2. To view edited program - While p

23OPERATION (cont.)Self-Diagnostic CodesSelf-diagnostic codes are displayed on the control board under the following conditions.Contact your MovinCool

24OPERATION (cont.)Empty the Drain TankDuring COOL mode, condensate water accumulates in the drain tank.When the drain tank becomes full, the “TANK FU

25OPERATION (cont.)Condensate Pump Kit (Optional)A condensate pump kits are available to allow continuous operation and to eliminate the need for a dr

26DAILY INSPECTION & MAINTENANCEEmpty the Drain TankTo empty the drain tank, refer to instructions on page 24.Clean the Air FiltersClean the air f

27DAILY INSPECTION & MAINTENANCE (cont.)In-Season/Off-Season Inspection & MaintenanceIn-SeasonWARNING: To prevent an accident due to electrica

28TROUBLESHOOTINGCheck the following items before calling your MovinCool reseller or a qualified technician.If conditions persist after the above acti

29TECHNICAL SPECIFICATIONS..*1: Serial number from April 2007 (0407) to September 2010 (0910)*2: Serial number from October 2010 (1010) to present*3:

OPERATION MANUALOFFICE PRO 12 / OFFICE PRO 18 / OFFICE PRO 24

30TECHNICAL SPECIFICATIONS (cont.)ITEMS/FEATURES Office Pro 12 Office Pro 18 Office Pro 24Operating ConditionsInlet air: MaximumMinimum95°F(35°C), 60%

WARRANTY STATEMENTDENSO PRODUCTS AND SERVICES AMERICAS, INC. ("DENSO") warrants its MOVINCOOL Products only to the extent stated in its offi

P/N: 484007-3582EN Third Issue: April 2013

Table of ContentsSERIAL NUMBER LOCATION AND IDENTIFICATION...2FOREWORD...

5FOREWORDCongratulations on purchasing the MovinCool portable air conditioner. This manual explains how to install and operate the MovinCool Office Pr

6GENERAL WARNINGS & CAUTIONS1. All electrical work, if necessary, should only be performed by qualified electrical personnel. Repair to electrical

7INVENTORYAfter unpacking your MovinCool unit, please check to make sure you have the following items:1. Office Pro 12 or Office Pro 18 or Office Pro

8INSTALLATIONChoosing an Installation SiteCAUTION: Following are some precautions to consider before choosing your installation site. Please review ca

9INSTALLATION (cont.)Moving the UnitUnlock the casters and push the MovinCool unit using the side handles to a flat, level surface and set the casters