Movincool Office Pro 10 Service Manual download pdf (Page 13)

CONSTRUCTION, SPECIFICATIONS, and DATA

2. Air Flow

Air is drawn from the intake ducts then passes

through the condenser which extracts the heat.

This hot air is blown out through the exhaust air

duct. Air taken in from the rear face is cooled by

the evaporator and then blown through the cool

air vent. All the air inlets are equipped with filters,

while the exhaust air outlet is protected by wire

mesh.

3. Compressor and Fans

The compressor is hermetically sealed. A two-

speed fan motor is used with centrifugal (back-

ward impeller) fans to draw air across the evapo-

rator. The condenser fan draws air over the

condenser section.

4. Drain Tank

The capacity of the drain tank is approximately

3.0 gallons (11 liters). The unit is equipped with a

“Tank Full” LED and a device to automatically

stop the operation of the unit when the drain tank

reaches a level of approximately 3.0 gallons (11

liters).

5. Condensate Pump (Optional)

The condensate pump will pump water from the

pump’s main tank to a nearby sink or floor drain.

The pump will lift the water a vertical distance of

18 feet. A plastic hose is supplied with the pump.

It is important that the drain line from the pump is

not kinked or bent.

EVAPORATOR

AIR IN

COOL

AIR OUT

CONDENSER



AIR IN

EXHAUST

AIR OUT

Condenser / Exhaust Air Flow

Air Flow

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

No comments

Movincool Office Pro 10 Service Manual Page 13