Movincool Office Pro 60 Service Manual download pdf (Page 13)

CONSTRUCTION, SPECIFICATIONS, and DATA

1. Basic Construction

The MovinCool Spot Cooling System is compact

in construction because the condenser and the

evaporator are enclosed in one unit. The interior

is divided into three sections. The upper front

face is equipped with the evaporator, while the

lower front face contains the drain tank (optional).

The rear section contains the condenser, the

compressor and the control box.

2. Air Flow

Air drawn from the right side face passes through

the condenser which extracts the heat. This hot

air is blown out through the upper exhaust air

duct. Air taken in from the front face is cooled by

the evaporator and then blown through the cool

air vent. All the air inlets are equipped with filters,

while the exhaust air outlet is protected by wire

mesh.

3. Compressor and Fans

The compressor is hermetically sealed. A two-

speed fan motor is used with two centrifugal fans

to draw air across the evaporator and condenser.

4. Drain Tank (Optional)

The capacity of the drain tank is 5.0 gallons (19

liters). The unit is equipped with a “Tank Full” LED

and a device to automatically stop the operation

of the unit when the drain tank reaches a level of

approximately 4.0 gallons (15 liters).

5. Condensate Pump

The condensate pump will pump water from the

pump’s main tank to a nearby sink or floor drain.

The pump will lift the water a vertical distance of

18 feet. A plastic hose is supplied with the pump.

The condensate pump is included with the Office

Pro 60. It is important that the drain line from the

pump is not kinked or bent.

EXHAUST

AIR OUT

CONDENSER

AIR IN

EVAPORATOR

AIR IN

COOL

AIR OUT

COOL

AIR OUT

Air Flow

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Comments to this Manuals

No comments

Movincool Office Pro 60 Service Manual Page 13

Comments to this Manuals

Related products and manuals for Split-system air conditioners Movincool Office Pro 60